Measure usable geometry

Record each physical stock piece separately with across-fabric width and lengthwise length. Total square inches or centimetres cannot prove that the required rectangles fit.

Enter every required cut

Assign each group to the correct fabric and preserve direction, rotation, orientation, and WOF-strip constraints. A geometric fit that violates grain or motif direction is not valid.

Read the status and unallocated pieces

No additional purchase means all entered cuts fit the stock. If not, Buy now gives the rounded shortfall and the purchased layout accounts for the unmet instances.

Test dimensions, not just total area

Four 10 × 10-inch squares need four physical placements. A 20 × 20-inch stock piece can hold all four; a 20 × 10-inch piece holds two, leaving two for the purchased layout. Conversely, a narrow remnant with enough square inches cannot satisfy a cut wider than the remnant. Check the project's status and the allocation for each physical piece before deciding that you have enough.

Decide whether the answer is ready to use

If Buy now is zero, the entered cuts fit the entered stock under the current constraints; verify those inputs include every cut and the real usable edges. If a result is marked Plan needs recalculation, update it before relying on the answer. Read warnings about WOF, direction, or planning limits, then use the named cutting allocations to locate the fabric that supplies each piece.

For one stock rectangle and one repeated piece, use Pieces from Fabric.

Check a complete project.