Direction changes which rotations are legal
A rectangle may physically fit after a quarter turn but place a one-way motif sideways. Before counting pieces, decide which edge must stay across the fabric and which runs down the bolt. Mark directional fabric and restrict rotation when that orientation matters. Piece-level restrictions override a fabric's general rotation setting in the planner.
For example, 12 pieces cut at 6 × 10 inches with 40 inches of usable width fit four across when the 10-inch edge runs across the fabric: three rows consume 18 inches. If a print must keep the 6-inch edge across, six fit across and two 10-inch-deep rows consume 20 inches. The first layout uses less length, but it is not an option when it turns the motif.
Width-of-fabric strips have a separate constraint
A width-of-fabric strip must span the usable crosswise width. It cannot rotate into the lengthwise axis merely because the dimensions fit. For example, a 2½-inch-wide WOF strip from 40-inch usable fabric consumes 2½ inches down the bolt and must remain 40 inches across. A 20 × 50 inch remnant cannot supply that strip even though its length exceeds 40 inches.
Check the cutting layout before purchasing
The fabric yardage calculator compares permitted orientations for one repeated rectangle. For several sizes or exceptions on individual pieces, use the project planner and inspect its cutting diagram. Record the print direction before using a lower-yardage result; a physically possible rotated layout may be unusable for your project.